|
The major parameters
Max. cutting thickness: 4mm
Max. cutting width: 2500mm
Intensity of the sheared material: 450N/mm2
Shearing angle: 1.5¡ã
Max. stroke of back gauge: 500mm
Times of stroke: 18 min-1
The length of balde: 2600mm
Height of the woek bench: 738mm
Main motor: Y112M-4, 4KW, 1440 RPM
Gear pump: 10MCY14-1B, 10L/min, 31.5Mpa
Diemension(L*W*H): 3200*1450*1500mm
Design & Inspection standard
JB5197-91: Shearing Machine Technique
JB/T 14404: Shearing Machine Accuracy
Characteristics
1) Blade part: The indicator to display cutting-edge gap adjustable value, the adjustment is simple and quick; logical display the shearing numbers.
2) Worktable part: For the work section equipment boom net to protect body¡¯s safety.
3) Front and back stock stop: The front stock stop on the worktable, indicate value by staff gauge, to reach the required stock value by adjust active stationary dog, when shearing the thin plate use the front stock stop is very easy; the back stock stop installed on up blade adapter, and it done luffing movement by up blade adapter, to adjust back stock stop by motor, transmission by screw after spped down by gearing, and it can manual micrometric.
4) Hydraulic system: It composed of control valve group, oil pump, cylinder, return cylinder, swagingcylinder, assembly hydraulic circuit and so on. The all system with the advantage like as reasonable construction, low noise, quick run, and good safety performance.
5) Electrical system: It composed of control electrical box, internal connect line, control panel, main and vice motors, foot pedal and so on. It with the advantage like as high safety factor, overall performance is high.
6) NC controller: The device adopts SNC-18 NC controller system specialized used in shearing machine, this controller system with the fellow control function:
a. It can display the location of back stock stop X, and shearing counting C;
b. When the screw with transmission back lash, can to set the compensation driven gap by parameter;
c. The system with soft limit function;
d. The system with specialized built-in time relay;
e.Can to set display scale factor in according of screw worm ratio, gear speed ratio, and can to auto calculate the display scale ratio by teaching function of the system;
f. With password protect function.
Main components
Blade material: 9CrSi/6CrW2Si
Blade manufacturer: Shanghai Shangpin Blade Producing Co.,Ltd.
Main motor type: Y Type
Main motor manufacturer: SIEMENS BEIDE
Electric system: SNC-18C
Hydraulic pump: Axial plunger pump
|
|
